Please select from the following pages

Gate Mounting & Components


Footing detail showing two pillars tied together including conduit placement

GM01

Pillar construction showing embedded steel angle and recessed control panel

GM02

Pillar with built-in steel angle and recessed control box

GM03

Existing pillars with mounting post attached with offset hinges

GM04

Auxillary post for mounting gate used with existing pillar

GM05

Close up of built-in angle and weld-on hinges

GM06

Exterior view of auxillary post installed at rear of existing pillar

GM07

Close-up of hydraulic gate operator and stainless steel control arms mounted on auxillary post

GM08

Gates mounted on 6x6 steel posts, base plates mounted on concrete pads

GM09

Gates mounted on 6x6 steel posts with base plates, showing footing detail and conduit into control box

GM10

Gates mounted on embedded 6x6 steel posts, offset hinges

GM11

Built in steel angle and recessed fiberglass control box

GC01

Built in steel angles and recessed fiberglass control box

GC02

Steel angles into stone pillars

GC03

Pillar with built in steel angles with photocell prep

GC04

Adjustable weld on gate hinge

GC05

Economy gooseneck stand

GC06

Basic gooseneck stand

GC07

Custom gooseneck stand

GC08

Custom gooseneck to accommodate digital entry and intercom

GC09

Custom gooseneck to accommodate digital entry intercom and keyswitch

GC10

Custom gooseneck to accommodate telephone entry and newspaper box

GC11

Basic gooseneck to accommodate telephone entry embedded

GC12

Commercial grade exterior backlit digital entry

GC15

Custom gooseneck stand showing gate layout

GC13

Steel or aluminum post with protective cap for digital entry

GC14

Steel or aluminum post for push button

GC16

Telephone entry surface mounted on stone wall

GC17

Telephone entry recessed into stone pillar

GC18

Custom kiosk to accommodate commercial telephone entry system

GC19

Custom kiosk to accommodate commercial telephone entry system

GC20

Cane bolts for swing gate with center stop

GC21

Treadle hose for exit or entrance gates

GC22

In ground exit loop cut into asphalt

GC23

In ground preformed exit loop laid in sand prior to pouring of asphalt driveway

GC24

Hydraulic gate operator with stainless steel control arms for swing gate

GC25

Screw drive gate operator mounted on embedded steel angles

GC26

Sliding gate with ground track and top guide roller

GC27

Sliding gate with rack and pinion top guide roller

GC28

Commercial slider with top guide roller and safety reversing edge

GC29

Sliding gate with rack and pinion operator

GC30

Cantilever carriage assembly and concrete pad

GC31

Cantilever carriage assembly and concrete pad

GC32

Sliding gate roller for ground track

GC33

Sliding gate with top guide roller

GC34

Special hinging to allow for upwards-sloping driveway

GC35

Special hinging to allow for upwards sloping driveway

GC36

Traffic light for gated community

GC37

Traffic light for gated community

GC38

Safety miller edges for bi-parting sliding gate

GC39

Surface mount fiberglass control box

GC40

Semi flush control box and pvc boxes

GC41

Recessed pvc control box

GC42

Control panel for swing gate operator

GC43

Surface mounted fiberglass control box with exterior antenna and sos

GC44

Remote mounted fiberglass control box embedded steel posts

GC45

Commercial custom control box mounted on pad to house gate components.

GC46

Fiberglass control box mounted on steel posts

GC47

Custom commercial steel box to house operator components for gated community

GC48

Saw cut for low voltage wiring

GC49